Group: DynoMotion	Message: 9750	From: andysontag	Date: 6/30/2014
Subject: "Bug unknown motion command"

Hi Tom,

I tried sending a simple gcode (i.e. Y10) command today and received a message that says "Bug unknown motion command". This happens every time I try to send a gcode command although not when I send M3, M5, etc. I searched the forum and couldn't find anything. Any idea on why this might be happening?

Andy

Group: DynoMotion	Message: 9751	From: Tom Kerekes	Date: 6/30/2014
Subject: Re: "Bug unknown motion command"

Hi Andy,

To do some sort of motion you must include what type of motion to do. For example G1 or G0.

Regards

Group: DynoMotion	Message: 9752	From: andysontag	Date: 6/30/2014
Subject: Re: "Bug unknown motion command"

Yep, that was it. Thanks Tom!

Andy